Hi,
I have problem about high pass filter circuit design. Carry out NI Multisim according to the infinite gain multi-feedback high-pass filter circuit provided by the related analog book. The cut-off frequency is 10MHz, and the component parameters are determined according to the caculating formulas from High Pass Filter Electronic Note, but in the simulation, the -3dB point in the Bode plot amplitude-frequency curve is around 8.5MHz instead of 10MHz.
Is there anyone can give me some ideas to figure it out? Many thanks.
Eva
I have problem about high pass filter circuit design. Carry out NI Multisim according to the infinite gain multi-feedback high-pass filter circuit provided by the related analog book. The cut-off frequency is 10MHz, and the component parameters are determined according to the caculating formulas from High Pass Filter Electronic Note, but in the simulation, the -3dB point in the Bode plot amplitude-frequency curve is around 8.5MHz instead of 10MHz.
Is there anyone can give me some ideas to figure it out? Many thanks.
Eva