You are currently viewing SemiWiki as a guest which gives you limited access to the site. To view blog comments and experience other SemiWiki features you must be a registered member. Registration is fast, simple, and absolutely free so please, join our community today!
I was just wondering about calibration circuits for phototransistors to account for degradation of the LED or phototransistor? Is that necessary, do they degrade quickly? Thanks
Good day, all
I have a small fan setup and I wanted to add a potentiometer to use as a variable resistor. I checked some steps of how to wire a potentiometer. I've come up with this design which uses a logarithmic potentiometer in place of a series resistor.
Initially, the red line did not...
I would like to place a non-polarized capacitor in between V1 and R1. Is it possible to replace the non-polarized capacitor(ceramic capacitor) with two polarized (electrolytic capacitors) C1 and C2 shown in the diagram above?
I have a very simple circuit on a breadboard with two push-button switches, an AND gate (74LS08), and an LED. I have the two switches hooked up to pins 1 and 2, while the LED goes from 3 to ground. Pin 14 is given 5 volts, while pin 7 goes to ground.
I'm just trying to test to see if the AND...
As far as the contact itself is concerned, except for the difference in contact current and contact materials, there is no difference. It has nothing to do with whether it is a time relay or an ordinary relay, and whether it is a normally open or normally closed contact.
Time relay and ordinary...